BELUGA fork tip
BIGForks
ManuTel®
CROC anti-slip/anti-noise coatings
DuplEx claddings
StainlessSteelForks
Stainless steel claddings
Swan-neck forks
FoldingForks
Upside-down forks
Fully-tapered forks
Cranked forks
SpecialForks
There are some goods that could be damaged by the inner heel radius of a StandardFork (i.e. wooden plates, sensitive pallets, etc.). The solution is swan-neck forks: The inner heel radius is offset to the rear. Thus, the nominal length of the fork can be completely used.
On the swan-neck fork the heel is offset to the rear, eliminating the risk of damage caused by the inner heel. This is particularly expedient when transporting goods without a transport carrier, e.g. wooden or metal sheets, furniture and paper.
The fork blade of the swan-neck fork can be completely exploited. This eliminates the risks posed by overhanging goods. At the same time the load centre of the forks and thus the residual capacity are unaffected, especially compared to the use of conventional end stops on the fork.
The loading process is thus fast, smooth and efficient.
Timber industry
Furniture industry
Paper industry
Metal industry / metal sheets
Share: