BELUGA fork tip
BIGForks
ManuTel®
CROC anti-slip/anti-noise coatings
DuplEx claddings
StainlessSteelForks
Stainless steel claddings
Swan-neck forks
FoldingForks
Upside-down forks
Fully-tapered forks
Cranked forks
SpecialForks
During day-to-day operations it is par for the course that goods and pallets with different lengths need to be moved.
The forklift truck’s standard forks are often too short or too long. The ideal solution is ManuTel® – the manual TelescopicForks made by VETTER. With ManuTel® you always have the “extension” to hand and ready for use in no time at all.
Loading and unloading trucks from one side or transport of two or three pallets at the same time.
PREVIOUSLY: installation time of fork extension of approx. 10 minutes
(search, fetch, install, lock, ... unlock, remove, take away, etc.)
NEW! ManuTel® < 1 minute required (unlock, extend, lock - READY!)
= a time saving of 9 minutes
Based on an hourly rate of €45,00 (forklift truck / driver) and 240 working days, this results in a time saving of 2,160 minutes = €1,620.00 per annum – for only one change of blade length per day and one forklift truck!
Always the right blade length!
No risk of accident due to protruding or short fork blades.
The underside of the ManuTel® G2 is closed off with a wear-resistant manganese steel plate.
It is thus protected against dirt, also suitable for use outdoors, has a long service life and can be used efficiently.
ManuTel® TelescopicForks are ready to use within seconds:
Remove the pin – pull out the fork shoe – replace the pin – READY! Without tools or additional hydraulics!
The length adjustment by means of locking pin is tried-and-tested, all over the world and under all ambient conditions.
ManuTel® forks are delivered with full documentation and in accordance with the requirements of the EC Machinery Directive (CE marking).
Their use thus meets all statutory requirements!
Forwarders and warehouses
DIY superstores
Transport of furniture, panels, wood or paper
Companies with varying load lengths
Share: